Correct Use; Useful Information - IKA Roller 6 basic Mode D'emploi

Use
For mixing and agitating liquids.
IKA Roller 6/10 basic
• Continuous mode for single or multiple test tubes.
IKA Roller 6/10 digital
• Continuous mode for single or multiple test tubes.
• Continuous mode for single or multiple test tubes.
Individual rollers can be removed to allow tubes of different sizes
to be processed. In this case the rollers automatically take up
symmetrical positions on the shaking table, so that the rollers
can be removed and inserted as desired.
• Check that the power supply matches the data on the ra-
ting plate.
• Plug the AC adapter into a standard mains socket in order
to supply the device with power. See the section "Technical
data" for the connection values.
• Also pay attention to the ambient conditions listed in the
"Technical data".
IKA Roller 6/10 basic
The AC adapter is suitable for 100 V upto 240 V. Insert an appro-
priate adapter corresponding to the country, before plugging the
AC adapter into the mains socket.
Switching the device on
Press the "Power" button (L) to switch the device on.
 The LED (M) lights up green.
Starting the device
Press the "Start/Stop" button (F) to start the shaking process.
The device starts at the preset speed of 30 rpm.
Stopping the device
Press the "Start/Stop" button (F) to stop the shaking process.
Switching off the device
Press the "Power" button (L) to switch the device off.
 The LED (M) goes out.
12

Correct use

Range of use:
Indoor environments similar to that a laboratory of research,
teaching, trade or industry.
The safety of the user cannot be guaranteed:
- If the device is operated with accessories that are not supplied
or recommended by IKA.
- If the device is operated improperly or in contrary to the IKA
specifications.
- If the device or the printed circuit board are modified by third
parties.

Useful information

The integral tube stopper prevents the tubes falling out.
For the safety of the operator, the device switches off automati-
cally if the rollers jam and/or can no longer rotate freely.
Commissioning
• The IKA Roller 6/10 basic does not restart automatically
when power is restored after a power outage. If the IKA
Roller 6/10 digital is running in mode A it does not restart
automatically when power is restored after a power outage.
If these conditions are met the unit is
ready for service when the mains plug
has been plugged in.