Safety Instructions - IKA Roller 6 basic Mode D'emploi

For your protection
Read the operating instructions in full before
starting up and follow the safety instruc-
tions.
• Keep the operating instructions in a place where they can
be accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational
health and safety and accident prevention regulations.
• Wear your personal protective equipment in accordance
with the hazard category of the medium to be processed.
Otherwise there is a risk of:
- splashing liquids
- projectile parts
- body parts, hair, clothing and jewellery getting caught.
• Set up the device in a spacious area on an even, stable,
clean, non-slip, dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for dama-
ge each time you use them. Do not use damaged compo-
nents.
Caution!
There is a crush hazard between the moving
parts and the casing.
• Place the test tubes safely between the rollers.
• Ensure accessory parts are secured carefully as test tubes
can be damaged or ejected otherwise.
• Always load the samples evenly on the device.
• The weight of the load must not exceed 2 kg. Do not ex-
ceed the maximum permissible shaking weights.
• Do not move or transport the device when it is operating or
connected to the power supply.
• Reduce the speed if
- medium sprays out of test tube due to excessive speed,
- the appliance is not running smoothly,
- dynamic forces start to cause the device and/or test tubes
to move around.
• The appliance is not suitable for manual operation.
• Beware of the risk of
- flammable materials
- glass breakage as a result of mechanical shaking power
Unpacking
• Please unpack the device carefully.
• In the case of any damage a detailed report must be sent immediately (post, rail or forwarder).
Delivery scope
• IKA Roller 6/10 basic/digital, depending on the type that was ordered
• AC adapter, see Fig. 1
• Plate SH
• Operating instructions
• Warranty card

Safety instructions

• The appliance may heat up when in use.
• Only process media that will not react dangerously to the
extra energy produced through processing. This also applies
to any extra energy produced in other ways, e.g. through
light irradiation.
• Process pathogenic materials only in closed vessels under
a suitable extractor hood. Please contact IKA if you have
any questions.
• Do not use the device in explosive atmospheres, it is not
EX-protected.
• With substances capable of forming an explosive mixture,
appropriate safety measures must be applied, e.g. working
under a fume hood.
• To avoid body injury and property damage, observe the re-
levant safety and accident prevention measures when pro-
cessing hazardous materials.
• Safe operation is only guaranteed with the accessories de-
scribed in the "Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• Disconnect the device from the power supply before you
open the cover or adjust the inclination angle of the device
shaking table.
• Do not operate the device with the cover open.
• The appliance can only be disconnected from the mains
supply by pulling out the mains plug or the connector plug.
• The socket for the mains cord must be easily accessible.
• The IKA Roller 6/10 basic does not restart automatically
when power is restored after a power outage. If the IKA
Roller 6/10 digital is running in mode A it does not restart
automatically when power is restored after a power outage.
For protection of the equipment
• The appliance may only be opened by experts.
• The voltage stated on the type plate must correspond to the
mains voltage.
• Removable parts must be refitted to the appliance to pre-
vent the infiltration of foreign objects, liquids etc.
• Protect the appliance and accessories from bumps and im-
pacts.
• The device must only be operated with the original plug-in
power supply unit.
Unpacking
Fig. 1
11