Read Me; Working In Supervisor Mode - Radiometer Analytical TitraLab TIM840 Guide D'utilisation

Read me!

The interface of the Titration Manager has been specially designed to
clearly guide you through every step of the programming and running of
the analyses, whether you are a supervisor or a routine user.
An important part of this interface is to check and control the presence
of different elements necessary to run the defined application.

Working in Supervisor mode

When programming in "SUPERVISOR" mode, it is recommended to
work in stages. These stages should be carried out in the order de-
scribed below:
To program a method
1. Define your electrode(s)
Identify electrodes (including temperature sensors) to be used for the
analysis.
Electrodes can be created from the following lists, Catalogue, Other or
Copy from. When creating the electrode, define if electrode calibration
is required (or not), if yes specify the "periodicity" of the calibrations and
the pH standards to be used. Refer to chapter 3.
27
Introduction