Configuration 2 - Room Probe - Palazzetti CALDAIA A PELLET JP Notice D'installation Et D'entretien

7.2 Configuration 2 - Room probe

1
6
Components included in the boiler
Configuration 2 is the default configu-
ration for this appliance. In this case it
is not necessary to make any changes.
Set configuration 2 to switch the appliance
on and off manually or in a programmed way
when the appliance is directly connected to the
radiators.
The appliance modulates the power according to
the room temperature read by the room probe
placed on the boiler itself.
You can set the "Eco-mode" function
to have the appliance switch off or on
again according to the room tempera-
ture set.
The antifreeze function can also be set in this
configuration.
48
T
Room temperature
probe
6
1
T
7.2.1 Room probe electrical connection
The appliance leaves the factory with the room
probe already connected to the terminals and
positioned on the rear panel (Fig. 26).
It is possible to place the room probe in another
place to detect the desired room temperature.
1
6
It is important to check that the appli-
ance is set in Configuration 2 (see "7.5.1
Software setting" on page 52).
004778300 ­ 14/09/2020
probe
temperature
room
Fig. 26