Installing The Unit - AVG TEXAS AVT-309CS2 Instructions D'installation Et Guide De L'usager

INSTALLING THE UNIT
Figure 1
Fig. 3a
Fig. 4
Step 1: Mark the leveling point of the hood. Position two mounting
screws on the wall, leaving 1/8" off the wall.
Step 2 Measure the width of the chimney then attach the chimney
:
mounting brackets to the wall at the desired height, taking
into account the minimum clearance between the hood
and the cooking surface (see installation drawing on page
20
Step 3: Align hood‐mounting holes to the screws on the wall and
hook the hood into place. Tighten screws to secure hood to
the wall. CAUTION: Make certain the range hood is secure
before releasing
Fig. 3b
Step 5: Plug the power cord into the socket (see Figure 4).
).
!
Step 4: Slide a 6" round metal venting tube over
the adapter / plug (see Figures 3a or 3b).
Seal the joints with metal tape
25
.