AVG TEXAS AVT-309CS2 Instructions D'installation Et Guide De L'usager page 28

OPERATING THE HOOD (continued)
Controls (continued):
• Adjusting the timer function:
While the blower is not running, press and hold Decrease (‐) button over 3 seconds to enter
•
timer mode. Adjust to desired time by pressing the Increase (+) or the Decrease (‐) button
(for minimum of 1 minute to a maximum of 15 minutes). This setting will be saved
immediately.
• Activating the timer function:
• While the blower is running, press and hold the Power button for over 3 seconds to activate
Power-off Delay Digital Timer. The Power-off Delay indicator will light up and Power-off
Delay Digital
• Adjusting the light:
• Press Light button once to turn lights on and once again to turn lights off.
• While the lights are off, press and hold Light button for over 3 seconds to adjust the intensity
of the lights. The level of brightness will be stored in system's memory.
CAUTION: DO NOT touch the lights until switched OFF and cooled.
NOTE:
Light settings are independent from other settings (including power-off delay) and lights have to be
manually turned on or off.
NOTE:
The system saves user configurations. Settings such as light, timer and blower speed will remain the same
the next time it is turned on.
Timer will begin to countdown; when it reaches zero, the blower will shut down.
28