Example:
1- The device is in Auto mode. The central control unit sent an Eco order
15,5°C.
auto
auto
mode
mode
2- By pressing
or
, you can change temporarily the desired tem-
perature up to 18°C for example.
auto
auto
mode
mode
Note: The cursor corresponding to the operating mode, i.e Eco mode in
our example, is blinking during the duration of the temporary deroga-
tion.
3- This modification will be automatically cancelled at the next order
sent by the central control unit or the transition to 00:00.
auto
auto
mode
mode
INFORMATION ABOUT PRIORITIES
BETWEEN THE DIFFERENT MODES
Principe
In Comfort, Eco and Frost protection modes, only orders of the
occupancy sensor and those of the open window sensor will be
considered.
In Auto mode, the device can receive different orders coming
from :
- 7 day and daily programming integrated (Comfort or Eco
orders);
- 6-order pilot wire if connected to central control unit;
- Open window detector;
- Occupancy detector.
In general, it is the lowest received order which prevails except
when the pilot wire is connected to an energy management system, in
this case the orders of the pilot wire take priority.
If an occupancy absence of more than 72 hours is detected, switching
to frost protection takes precedence unless a load shedding order is pre-
sent on the pilot wire.
Special case of self-programming where the temperature level in the
room is decided according to the learning of the lifestyle and the opti-
mization mode selected (Opti Comfort or Opti Eco):
- During the programmed passage in period Eco, if a presence is detec-
ted in the room, it will be taken into account and the appliance auto-
matically switches to Comfort mode
- During the programmed passage to the Comfort mode period, the ab-
sence detection system is temporarily suspended (30 minutes).
prog
prog
boost
3
OK
OK
prog
prog
boost
3
OK
OK
prog
prog
boost
3
OK
OK
In case of programmed Boost, the Boost activation will take precedence
over others orders received except when the standby (stop) order is pre-
sent on the pilot wire, the device will switch off and the Boost will be
not activated.
• Examples
7 day and daily programming
Pilot wire 6 orders
Eco
7 day and daily programming
Pilot wire 6 orders
Occupancy detector
Frost protection
7 day and daily programming
Pilot wire 6 orders
Occupancy detector
Open window detector
Standby mode
OPTIONAL: REMOTELY MANAGEMENT BY
RF REMOTE CONTROL
• Overview
Your device can be managed by a wireless RF remote control.
Only the RF pairing procedures to operate on the controller are described
in this instructions manual.
For installing and using the remote control, refer to its instructions
manual.
• RF pairing between the remote control and the blower
The remote control and the blower are not bonded together at the
factory, then proceed as follow:
1- From Frost protection mode, press
auto
auto
mode
mode
EN
= Comfort
= Eco
auto
auto
prog
prog
3
= Comfort
OK
OK
mode
mode
= Eco
= Frost protection
auto
auto
prog
prog
3
= Eco
OK
OK
mode
mode
= Stop (standby mode)
= Eco
= Frost protection
auto
auto
prog
prog
OK
OK
mode
mode
for 5 seconds.
prog
prog
boost
OK
OK
5 sec.
boo
boo
boo
10