2- The blower is in pairing mode.
Then proceed to the remote control pairing (refer to its installing and
using instruction manual).
auto
auto
mode
mode
3- When both blower and remote control are linked, the
pears and is constantly displayed. The blower returns automatically
to the frost protection mode.
auto
auto
mode
mode
• Check the RF signal strengh
You can check at any time the RF transmission performance between
the blower and the remote control.
To view the RF reception level, from Frost protection mode, press
5 seconds. Then the level appears on the display.
auto
auto
mode
mode
1
= Low RF transmission level:
To improve the RF transmission performance between the 2 de-
vices and ensure the remotely management is optimized:
- Please ensure the RF transmission is not interrupted, move the
remote control.
- Move the remote control closer to the blower.
10 = High RF transmission level, the location of the remote control is
optimized.
• RF pairing cancellation
You can cancel at any time the RF transmission between the blower and
the remote control.
From Frost protection mode press simultaniously on
seconds.
auto
auto
mode
mode
5 sec.
prog
prog
boost
OK
OK
symbol ap-
prog
prog
boost
OK
OK
prog
prog
boost
OK
OK
5 sec.
and
for 5
prog
prog
boost
OK
OK
The
symbol disappear from the display, the remote control and the
blower are not associated.
for
auto
auto
prog
prog
boost
OK
OK
mode
mode
EN
11