Restoring Factory Settings - RADSON Flores C E Notice D'utilisation

PIN code initialisation
By default, the PIN code is not enabled.
1- By default registered PIN code is 0000.
Press or to select 0. It is blinking. Save by pressing
auto auto
mode mode
1
2- For others numbers, select 0 by press
When 0000 appears, press on
auto auto
mode mode
The PIN code is initialized, the next setting automaticaly appears:
PIN Code activation.
Activation/deactivation of the PIN Code
OFF
1- appears on the display.
Press or to enable PIN code.
ON
appears on the display.
ON
= PIN code enabled
OFF
= PIN code disabled
auto auto
mode mode
2- Press to save and return to the home installer settings display.
auto auto
mode mode
The PIN code is enabled. Any modification of reserved settings listed in
"Overview" is now impossible.
Customizing the PIN code
If you have just activated the PIN code, follow the stages described be-
low.
Alternatively, you must copy the steps 1 and 2 of the initialisation
process as well as the steps 1 and 2 of the activation process
before personalising the PIN code.
OFF
appears on the display.
prog prog
boost
OK OK
2
.
again to save and exit.
prog prog
boost
OK OK
prog prog
boost
OK OK
prog prog
boost
OK OK
Please remember that the personalisation of the PIN code can
only be set once the initialisation and activation of the PIN code
has been completed.
On
1- When appears, press
.
2- The 0000 code appears and the first number blinks. Press
to select the first desired number then press
Repeat this operation for remaining 3 numbers.
3- Press to confirm. The new code is now saved.
4- Press again on
home display of the installer settings.
To exit the Installer settings, press

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user and installer settings are
re-initialized:
1- From the PIN code setting, press
display.
for at least 5 seconds.
auto auto prog prog
boost
OK OK
mode mode
5 sec.
auto auto prog prog
boost
OK OK
mode mode
1 2
auto auto prog prog
boost
OK OK
mode mode
to exit setting PIN code mode and go back to the
auto auto prog prog
boost
OK OK
mode mode
twice.
rest
. appears briefly on the
auto auto prog prog
boost
OK OK
mode mode
EN
or
to save and exit.
16