Restoring Factory Settings; Technical Specifications - RADSON Flores C E Notice D'utilisation

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user, installer and expert set-
tings are re-initialized:
1- From the Power setting setting, press
play.
auto auto
mode mode
NO
2- appears. Press or
auto auto
mode mode
yes
= Factory settings reset
NO
= Factory settings not reset
3- Press the key for 5 seconds. The device returns to its initial confi-
guration and goes back automatically to the Auto mode.
auto auto
mode mode
The following factory values will be effective:
Settings
Operating
Comfort setting temperature
Boost duration
Keypad lock
User settings
Backlighting
Eco mode temperature lowering-
level
Frost protection temperature
Minimum set of Comfort setting
temperature
Maximum set of Comfort setting
temperature
Maximal Boost duration
Maximum ambient temperature
for the automatic stop of the
Boost
Temperature unit
Installer settings
Automatic open window
detection
rest
. appears on the dis-
prog prog
boost
OK OK
YES
to select .
prog prog
boost
OK OK
prog prog
boost
OK OK
5 sec.
Factory settings
19°C
60 min.
Disabled
L3
-3,5°C
7°C
7°C
30°C
60 min.
39°C
°C
Enabled
Settings
Occupancy detection
Dual optimization feature
PIN code protection
Value of the PIN code
Experts settings
Power
To exit the Expert settings, press
TECHNICAL
SPECIFICATIONS
General specifications:
- Operating voltage: 230V +/-10% 50Hz.
- Maximum power of 1500W, resistive load.
- Power supply cable: 800mm, 3 Conductors.
- Radio frequency: 2,4035 Ghz/ 2,4055 Ghz / 2,4075 Ghz.
- Maximum RF power transmitted: <1mW.
- Standby consumption : <0.5W.
- Electronic PID (Proportional Integral Derivative) control, trigge-
red by a triac.
Compliance declaration: we hereby declare un-
der our sole responsibility that the products des-
cribed in these instructions comply with the pro-
visions of Directives and harmonized standards
listed below:
- RED 2014/53/EU:
Article 3.1a (Safety): EN60335-1/ EN60335-2-30/ EN60335-2-43/
EN62333;
Article 3.1b (EMC): ETSI EN301489-1 / ETSI EN301489-3;
Article 3.2 (RF): ETSI EN 300440;
- ERP 2009/125/CE;
- Regulation 2015/1188/UE;
- ROHS 2011/65/EU: EN50581
and are manufactured using processes which are certified ISO 9001
V2008.
The symbol affixed on the product indicates that you must
dispose of it at the end of its useful life at a special recycling
point, in accordance with European Directive WEEE 2012/19/
EU. If you are replacing it, you can also return it to the retailer
from which you buy the replacement equipment. Thus, it is not
ordinary household waste. Recycling products enables us to
protect the environment and to use less natural resources.
EN
Factory settings
Enabled
Opti comfort
Disabled
0000
500W
3 times.
19