Comfort Setpoint Temperature Limit; Setting Of The Maximum Duration Of Authorised Boost; Setting Of The Maximum Ambient Temperature For The Automatic Stop Of The Boost; Setting The Temperature Unit - RADSON Flores C E Notice D'utilisation

COMFORT SETPOINT TEMPERATURE
LIMIT
You can limit the setting temperature range by introducing a maximum
and / or minimum setting, preventing unintentional changes in tem-
perature.
• Low temperature limit
Locking of the setting range using a minimum temperature stop, pre-
venting the temperature from being set below that temperature.
The minimum setting is preset to 7°C. You can adjust from 7°C to 15°C
by intervals of 1°C.
7- To change the minimum temperature setting, press
save by pressing .
If you do not want to change it, press
auto auto
mode mode
1
matically to set the maximum setting. To exit the user settings, press
twice.
• High temperature limit
Locking of the setting range using a maximum temperature increase,
preventing the temperature from being set above that
temperature.
The maximum setting is preset to 30°C. You can adjust from 19°C
to 30°C by intervals of 1°C.
8- To change the maximum temperature setting, press
To save and move automatically to the next setting, press
auto auto
mode mode
To exit the user settings, press
SETTING OF THE MAXIMUM DURATION
OF AUTHORISED BOOST
The maximum duration of Boost is preset at 60 minutes. You can adjust
it from 30 to 90 minutes by intervals of 30 minutes.
9- The Boost symbol and the heating indicator appears on the display
and the preset duration of 60 minutes flash.
auto auto
mode mode
or
: the device changes auto-
prog prog
boost
OK OK
2
or
prog prog
boost
OK OK
1 2
twice.
prog prog
boost
OK OK
10- Press or
11- To save and move automatically to the next setting, press
then
To exit the user settings, press
SETTING OF THE MAXIMUM AMBIENT
TEMPERATURE FOR THE AUTOMATIC
STOP OF THE BOOST
When the Boost is enabled, the device has to heat the room until the
temperature limit: the maximum ambient temperature.
When it is reached, the Boost stops automatically.
It is preset at 39°C, you can adjust it from 25°C to 39°C by intervals of
1°C.
The Boost symbol and the heating indicator appear on the display and
.
the maximum temperature flashes.
.
12- You can set the Boost maximum temperature by pressing
from 25°C to 39°C by intervals of 1°C.
13- To save and move automatically to the next setting, press
exit the user settings, press

SETTING THE TEMPERATURE UNIT

The pre-set temperature unit is degrees Celsius.
14- Press or
to display the desired duration.
auto auto prog prog
OK OK
mode mode
auto auto prog prog
OK OK
mode mode
twice.
auto auto prog prog
OK OK
mode mode
twice.
to change the temperature unit.
auto auto prog prog
OK OK
mode mode
EN
boost
.
boost
or
boost
. To
boost
13