Description; Area Of Application; Technical Data; Conditions Of Use - Burkert S020 Manuel D'utilisation

5.

deScripTion

5.1.

Area of application

The S020 fitting simplifies the installation of insertion devices for mea-
suring flow, pH, oxidation reduction potential (REDOX) or conductivity
on DN6 to DN400 pipes.
The fitting S020 is available in various versions for the installation of
measuring devices with a G2'' nut or measuring devices with a clamp
process connection.
The S020 measuring chamber is used:
• on the one hand, to install an insertion device for measuring the
pH, the oxidation reduction potential or the conductivity in a pipe
• and, on the other hand, to guarantee that the measurement sensor
is fully covered by the fluid.
8
English
Type S020
Description
6.

TechnicAl dATA

6.1.

conditions of use

Fluid depends on the device inserted and the material
temperature from which the S020 fitting is made. Refer to the
operating instructions for the device and to the tem-
perature/fluid pressure dependency curve in Fig. 5.
If the ranges are different, use the most restrictive
range.
Ambient depends on the device inserted into the S020.
temperature Refer to the related operating instructions.
Pressure depends on the device inserted and the material
class from which the S020 fitting is made. Refer to the
operating instructions for the device and to the tem-
perature/fluid pressure dependency curve in Fig. 5.
If the pressure classes are different, take the lowest
value into account.
6.2.

Available certificates

• Certificate 3.1, S020 in stainless steel only
• Certificate 2.2
• Surface roughness certificate
• Calibration certificate
• FDA approval (with EPDM seal), S020 in stainless steel only