OPERATION
Cleaning, care and maintenance
6
5
4
3
2
1 Temperature setting OFF
2 Temperature setting warm
3 Descaling setting
4 Temperature setting warm to hot (steaming)
5 Temperature setting hot (steaming) to boiling
6 Boiling end stop
f Turn the temperature selector straight to the boiling end
f
stop.
f Switch the appliance on by pressing the temperature
f
selector.
The ON/OFF indicator illuminates while the water is heated.
Once the selected temperature has been reached, the appliance
switches itself off automatically following a system-dependent
delay. The ON/OFF indicator goes out.
The temperature at which the appliance turns off can vary depend-
ing on the fill level, the degree of scaling and the residual heat.
f If necessary, you can bring the water straight back to boiling
f
point by keeping the temperature selector pressed.
f You can stop the heating process at any time by turning the
f
temperature selector to OFF.
f Draw the water off via the tap.
f
www.stiebel-eltron.com
5.
5.1
Almost every type of water will deposit lime at high temperatures.
1
Therefore, it is necessary to descale the appliance every so often.
f Use environmentally compatible formic acid-based descaling
f Do not the boil water during descaling.
f When the appliance has cooled down, open the cover.
f Fill the appliance with the recommended amount of water
f Turn the temperature selector to the descale setting (see
f Switch the appliance on by pressing the temperature
f Leave the descaling agent to take effect and repeat the heat-
f Draw off all the water and rinse the appliance out several
f Boil the maximum possible volume of water and draw this
5.2
f Never use abrasive or corrosive cleaning agents. A damp
The inside of the appliance's glass container can be cleaned if
necessary:
f Isolate the appliance from the power supply.
f When the appliance has cooled down, open the lid.
f Clean the container and heating element without using any
f Close the lid and plug in the mains plug again.
f If necessary, rinse out the appliance in order to remove any
Cleaning, care and maintenance
Descaling
WARNING Burns
Descalers that generate a lot of foam can result in the
appliance overflowing, which would put users at risk.
f
agents.
f
f
f
and descaling agent and close the cover.
f
diagram).
f
selector.
f
ing process if necessary.
f
times with cold water.
f
water off once again.
Cleaning
f
cloth is sufficient for cleaning the appliance.
f
f
f
objects with sharp edges.
f
f
cleaning agent residue.
EBK G | EBK GA |
17