Use; Switching On; Standard Configuration - Nuova Simonelli MICROBAR II Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
4.

USE

Before starting usage of the appliance, the operator
must read and fully understand the safety instruc-
tions in this handbook.
If the self-diagnostic function indicates anom-
alies or failures, call the assistance centre.
Operators must never intervene.
4.1

SWITCHING ON

NOTE: In case the following procedure shouldn't
take effect, see the chapter on "Problems
and Solutions".
Press the main switch so that the LCD display
turns on showing the message:
MICRO2015R.1.13B
At the same time, the machine automatically fills
the heater with water and begins heating opera-
tions, and then, after few seconds, the display
will show:
Please Wait
Heating
At the end of the heating cycle, the machine is
ready and the display will read:
Machine Ready
Day
NOTE: The starting time is about 3 minutes.
NOTE: The appliance is equipped with a secu-
rity system that will stop the machine after
about 1.5 minutes of continuous functioning
of the pump (to avoid pump overheating). In
this case, switch off the main switch of the
machine and then turn it on again.
The machine is now ready to be used.
CAUTION
Hour
4.2
SWITCHING OFF
To switch off the machine, proceed as follows:
Hold the "ENTER" key down for 5 seconds with
the machine switched on
The LCD will read as follows:
Machine Off
Day
To stop the machine completely, press the main
switch and turn it to the "OFF" position.
4.3
STANDARD
CONFIGURATION
KEY

(Standard Configuration)

1 Espresso
1 Coffee
Decaffeinated coffee
Cleaning Cycle
Hot water
NOTE:
Keys 1-2-3-4-6 (see DISPLA ' description) may cor-
respond to a different beverage according to one's
taste and local habits (see chapter PROGRAMMING
and paragraph SELECTIONS CONFIGURATION).
.
Hour
OFF
Fig. 15
2 Espresso
2 Coffees
Caffelatte
Steam
51

Publicité

Table des Matières
loading

Table des Matières