Nuova Simonelli MICROBAR II Manuel D'instructions page 66

At the end of this cycle, the display will read as
follows:
Rinse
Refill WaterTank
Rinse out the tank and refill it with clean water
(without switching off the machine).
NOTE: Use at least 4 litres (1.06 gal) of solution,
otherwise it will be necessary to restart the
cycle.
Wait at least 5 minutes.
At the end, the display will read as follows:
Rinse
Press ENTER
Press the ENTER key and the machine will begin
a rinse cycle, taking 2 litres of water from the
container and then expelling it through the nozzle.
During this stage, the machine display will read as
follows:
Rinse
Please Wait
When the machine has finished the 2 litres taken
from the container, the display will again read:
Rinse
Press ENTER
Press the ENTER key again for the machine to start
the second stage of the rinse cycle, taking a further
2 litres from the container. The machine display will
then read:
Rinse
Please Wait
At the end of the rinse cycle, the machine display
will read as follows:
Heating
Please Wait
Leave the machine to heat up for a few minutes; at
the end of this time, the machine will return to its
ready status.
56
During the heating phase, some drops of water
and steam may come out from the hot water
nozzle.
At the end of the descaling cycle, it is recom-
mended to activate the steam for some minutes.
EN
CAUTION
CAUTION