Switching On; Switching Off - Nuova Simonelli MICROBAR II Manuel D'instructions

EN
2.4

SWITCHING ON

After the preliminary operations:
1 Press the machine's main switch and turn it to
"ON".
The LCD will then light up and read as follows:
MICRO2015R.1.13B
The machine automatically loads the heater with
water and begins heating operations.
The display will show the following display until
the end of heating:
Please Wait
Heating
When the desired temperature is reached, the
display will show the following message:
Machine Ready
Day
NOTE: The appliance is equipped with a secu-
rity system that will stop the machine after
about 1.5 minutes of continuous functioning
of the pump (to avoid pump overheating). In
this case, switch off the main switch of the
machine and then turn it on again.
The machine is now ready to be used.
ON
Fig. 10
Hour
WHEN INSTALLING THE MACHINE FOR THE
FIRST TIME OR AFTER WATER HEATER UNIT
MAINTENANCE, PRESS THE BUTTON TO DIS-
PENSE HOT WATER BEFORE DISPENSING COF-
FEE. REPEAT THIS OPERATION AS REQUIRED
AND UNTIL THERE IS AN EVEN FLOW OF
WATER FROM THE NOZZLE.
2.5

SWITCHING OFF

To switch off the machine, proceed as follows:
Hold the "ENTER" key down for 5 seconds with
the machine switched on
The LCD will read as follows:
Machine Off
Day
To stop the machine completely, press the main
switch and turn it to the "OFF" position.
CAUTION
.
Hour
OFF
Fig. 11
49