Docking And Dedocking; Docking: Fig.6.1 - Fig.6.6 - Sunrise Medical Quickie Attitude Power Notice D'utilisation

6.0 Docking and Dedocking

WARNING!
• Always make sure that the device is switched off
before docking and dedocking.
• Ensure the wheelchair is fully connected with the add-
on bike before use.
• As with all moving parts, there is a risk that fingers and
/ or clothing could become trapped. Please always
handle carefully.
Refere to the docking check list below:
Docking Pins
Fully locked In
Docking Levers
Fully Locked In
Fig.6.0
CAUTION!
• Always keep the docking system clean.
• Clean it after every trip paying particular attention to
sand and mud.

Docking: Fig.6.1 - Fig.6.6

• Drive your wheelchair as close as possible to the add-
on bike.
• The 2 docking pins on your wheelchair should stay
directly in front of the lower docking connector.
• The add-on bike should stand on an even surface.
• Lock the brakes of your wheelchair.
• Pull it towards you by using the handlebars, until the 2
docking pins lock in, A.
• Now push the add-on bike upwards/forwards until the
stand wheels and the castors leave the ground.
• Swing the upper docking connector downwards until it
stops, B.
• Lower the add-on bike until the upper docking
connector is in contact with the front frame of your
wheelchair.
• Pull the red locking lever backwards until it locks firmly
and completely, C.
• Clamping must be on the metal tube without any parts,
(e.g. calf strap, frame protectors), in between.
• Ensure the wheelchair is fully connected with the add-
on bike, (see Fig.6.0).
Attitude Power Rev.2.0
Fig.6.1
Fig.6.2
√
√
Fig.6.3
Fig.6.4
Fig.6.5
A
B
C
13