How To Return One Touch To Factory Default Settings; Directional Control - Clarke Focus 28” Disc iDrive Manuel D'utilisation

How To Operate The Machine

How to Return One Touch to Factory Default Settings

To restore the factory settings, follow the procedures below:
1. Press and hold the green one touch button (figure 17, B)
until you hear a double beep from the machine. NOTE:
The time required for this will be approximately 15
seconds.
2. The settings should be returned to 2 bars of solution and
1 bar of brush pressure. NOTE: The squeegee vac
switch must be in the middle position for default
settings to work.
Directional Control (see figure 18, A and B)
The Focus Rider Scrubber is equipped with a joystick for
controlling speed and direction of the machine. Simply
point the joystick in the direction you want the machine to go
(figure 18, A). This is true for both forward and reverse
directions. The speed and direction are directly proportional
to the position of the joystick. If you want to go slow and
straight, apply a slight amount of pressure to the joystick in
the forward direction. For more speed, move the joystick
further in direction you wish to travel.
NOTE: See example in figure 18, B - the joystick is
positioned to where the machine will go in the forward-right
direction.
How to Move the Machine Without Power (see figure 19)
1. Engage manual override on brake (see page 9, "Parking
Brake").
2. Remove foot plate and 4 screws and locate steering
motor.
3. Using the knob on steering motor, turn shaft on motor in
direction you wish to turn machine.
4. Slowly push machine to desired location. NOTE: If you
attempt to push machine too fast it will limit top speed.
If this happens, stop and restart.
5. After moving machine, disengage manual brake
override. NOTE: Machine will not function if override is
engaged.
Clarke ®
Operator's Manual (EN) - Focus Rider
ENGLISH
(Top View)
Forward Left
Reverse Left Reverse Right
Figure 18
Figure 19
EN
A
B
Forward Right
- 17 -