How To Operate The Machine; How To Return One Touch To Factory Default Settings; How To Move Machine; Seat Adjustment - Clarke FOCUS 00310S Manuel D'utilisation

ENGLISH
EN

How To Operate The Machine

How to Return One Touch to Factory Default Settings

To restore the factory settings, follow the procedures below:
1. Press and hold the green one touch button (fi gure 17) until you
hear a double beep from the machine. NOTE: The time re-
quired for this will be approximately 15 seconds.
2. The settings should be returned to 2 bars of solution and 1 bar of
brush pressure. NOTE: The squeegee vac switch must be in
the middle position for default settings to work.
How to Move the Machine Without Power (see fi gure 18)
1. Engage manual override on brake (see page 9, "Parking
Brake").
2. Remove foot plate and 4 screws and locate steering motor.
3. Using the knob on steering motor, turn shaft on motor in direc-
tion you wish to turn machine.
4. Slowly push machine to desired location. NOTE: If you attempt
to push machine too fast it will limit top speed. If this hap-
pens, stop and restart.
5. After moving machine, disengage manual brake override.
NOTE: Machine will not function if override is engaged.
Seat Adjustment (Standard)
The standard seat is not adjustable forward or backward.
Seat Adjustment (Deluxe)
The optional deluxe seat is adjustable in three ways:
1. The seat can be adjusted to the forward/backward position by
using the lever on the lower right side of the seat . Moving the
lever will allow the seat to slide into the preferred position. See
fi gure 19.
2. To adjust the angle of the back support portion of the seat, turn
the lever located in the middle right position of the seat. Turning
this clockwise will make the seat more vertical. Turning the knob
counterclockwise will tilt the seat back.
See fi gure 20 A.
3. To adjust the suspension of the seat for operator comfort, use the
lever on the side of the back support section of the seat. This has
three positions. The upper position is for light weight operators.
The middle position is for medium weight operators. The bottom
position is for heavy weight operators. See fi gure 20, B. NOTE:
The lever must be pressed fi rmly to change positions.
Page -16- Form No. 71171A
Figure 17
Figure 18
Figure 19
Figure 20
Clarke ® Operator's Manual (EN) - Focus Rider