Rear Squeegee Blade Replacement - Clarke Focus 28” Disc iDrive Manuel D'utilisation

ENGLISH
EN
Maintenance

Rear Squeegee Blade Replacement

If the rear squeegee blade is worn and does not dry the
floor well, follow this procedure:
1. Remove the squeegee assembly from the
machine.
2. Remove the squeegee blade and inspect it.
3. Rotate the squeegee blade to obtain a new
cleaning edge. Replace if necessary.
4. Reinstall the squeegee blade.
5. Reinstall the squeegee assembly on the
machine.
6. Readjust the settings on the squeegee as
required (see "How to Adjust Squeegee").
Squeegee Maintenance
The squeegee blade may be rotated for longer life.
Keep sharp corner on floor for best cleaning
results. See figure 40. To rotate follow this
procedure:
1. Remove Clamp.
2. Remove blade and rotate to new edge.
3. Replace squeegee.
4. Replace clamp.
Cleaning the Vacuum Hoses
Make sure the squeegee is over a suitable drain.
1. Use a garden hose to flush through the recovery
hoses.
2. Side Squeegee - Position garden hose to the
squeegee side of the hose and flush thoroughly.
3. Recovery Hose - Position water hose
inside recovery tank. Recovery hose is located
behind threaded lip (see figure 41, A). NOTE: Do
not place hose in vacuum intake tube (see
figure 41, B), damage will occur.
Re-center Front Wheel
If the front wheel gets out of adjustment and the
machine does not drive straight when the joystick is
pointed forward, follow this procedure:
1. Remove 4 screws holding foot plate to solution
tank (see figure 42).
2. Locate two black wires tied together and marked
"reset sw" (see figure 43).
Page -28-
Figure 40
A
Figure 41
Figure 42
Figure 43
Clarke ®
Operator's Manual (EN) - Focus Rider
B