Introduction; Manual Purpose And Contents; Target; How To Keep This Manual - Clarke RSW 37 Manuel D'utilisation

ENGLISH

INTRODUCTION

NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.

MANUAL PURPOSE AND CONTENTS

The purpose of this Manual is to provide the operator with all necessary information to use the machine properly in a safe and
autonomous way.
It contains information about technical data, safety, operation, storage, maintenance, spare parts and disposal.
Before performing any procedure on the machine, the operators and qualifi ed technicians must read this Manual carefully.
Contact Clarke in case of doubts regarding the interpretation of the instructions and for any further information.

TARGET

This Manual is intended for operators and technicians qualifi ed to perform the machine maintenance.
The operators must not perform procedures reserved for qualifi ed technicians. Clarke will not be responsible for damages
coming from failure to follow these instructions.

HOW TO KEEP THIS MANUAL

The Operator's Manual must be kept near the machine, inside an adequate case, away from liquids and other substances that
can cause damage to it.

IDENTIFICATION DATA

The machine model and serial number are marked on the plate (41) applied on the frame and can be read by opening the
machine hood (10).
The machine production year is indicated by the fi rst two fi gures of the machine serial number.
This information is useful when requiring machine spare parts. Use the following table to write down the machine identifi cation
data.
MACHINE model ...............................................................................
MACHINE serial number ...................................................................

OTHER REFERENCE MANUALS

– Electronic Battery Charger Manual, to be considered an integral part of this Manual
Moreover, the following Manuals are available:
– Service Manual (that can be consulted at any Clarke Service Center)

SPARE PARTS AND MAINTENANCE

All necessary operating, maintenance and repair procedures must be carried out by qualifi ed personnel or by Clarke Service
Centers listed at the end of this Manual. Only original spare parts and accessories must be used.
Call Clarke for service or to order spare parts and accessories, specifying the machine model and serial number.

CHANGES AND IMPROVEMENTS

Clarke constantly improves its products and reserves the right to make changes and improvements at its discretion without
being obliged to apply such benefi ts to the machines that were previously sold.
Any change and/or addition of accessory must be approved and performed by Clarke.

OPERATION CAPABILITIES

This sweeper has been designed and built to clean (by sweeping and vacuuming) smooth and solid fl oors, in civil and industrial
environments and to collect dust and light debris under safe operation conditions by a qualifi ed operator.

CONVENTIONS

Forward, backward, front, rear, left or right are intended with reference to the operator's position, that is to say on the driver's
seat, with the hands on the steering wheel (1).
2
Operator's Manual - RSW 37