How To Operate The Machine; How To Operate The I-Drive Controls; Horn Operation; One Touch Operation - Clarke Focus 28” Disc iDrive Manuel D'utilisation

ENGLISH
EN

How To Operate The Machine

How to Operate the i-Drive Controls

The following controls are located on the joystick:
1. Horn : The horn is a red button located on the top of the
joystick (figure 17, item A). NOTE: The horn sounds
continuously when pressed and intermittent and
automatic in reverse.
2. One Touch: The one touch button is a green button located
on the upper front of the joystick (figure 17, item B). NOTE:
For more information about the one touch control see
below.
3. Speed Selector: The speed selector is a black button
located on the lower front of the joystick (figure 17, item C).

Horn Operation

The horn is a continuous tone when pressing the horn button. In
reverse the horn pulses automatically.

One Touch Operation

One touch cleaning is a feature on the Focus Rider Scrubber. The
factory defaults for this setting are 1 bar of brush pressure and 2
bars for solution flow and squeegee in the down position.
1. Press and release the green button for all cleaning
functions to begin.
2. The squeegee and brush head lower to the floor and the
vacuum starts.
3. The brushes and solution will begin only when you begin to
traverse.
4. The cleaning will be at the factory default settings, however
you can reprogram these settings to your specifications.
See "Reprogramming One Touch" section below.
5. To end cleaning process, press the green button again and
solution will stop; brushes will raise; after a short delay
squeegee will raise; and the vacuum motor will turn off.
NOTE: It is intended that this be done while traversing.

Reprogramming One Touch

If you do not want to use the factory default settings, you may
reprogram the setting by following the procedures below:
1. Place the machine in the desired scrub condition by using
the one touch and / or individual switches.
2. Press and hold the green one touch button until you hear a
single beep from the machine then release the button.
NOTE: The time required should be approximately 5
seconds.
3. When you activate or deactivate the one touch, it will now be
set to your preference for cleaning. These settings will
remain until you disconnect power or reprogram them.
NOTE: When programming one touch, be sure squeegee
is in automatic (middle) position, otherwise you may
program squeegee either up or down all the time.
Page -16-
Figure 17
Clarke ®
Operator's Manual (EN) - Focus Rider
A
B
C