Maintenance; Maintenance To Be Done Every Week; Battery Inspection And Cleaning; Cleaning The Recovery Tank And Filter - Clarke Focus 28” Disc iDrive Manuel D'utilisation

ENGLISH
EN

Maintenance

Maintenance To Be Done Every Week

WARNING: Maintenance and repairs must be
done by authorized personnel
only. Always empty the solution
tank and the recovery tank before
doing any maintenance. Keep all
fasteners tight.
WARNING: Always wear eye protection and
protective clothing when working
near batteries. NO SMOKING! Do
not put tools or other metal
objects across the battery
terminals or the tops of the
batteries.
CAUTION: To prevent damage to the
machine, and discharge across
the tops of the batteries, do not fill
the batteries above the bottom of
the tube in each cell. Wipe any
acid from the machine or the tops
of the batteries. Do not add acid
to batteries after installation.

Battery Inspection and Cleaning

1. Turn the key switch to the "OFF" position.
2. To inspect batteries, rotate seat support forward.
Lift and rotate recovery tank. Be sure the recovery
tank is empty before lifting.
3. Disconnect the batteries. Use a cloth and a solution
of ammonia or bicarbonate of soda to wipe the top of
the batteries. Clean the battery terminals. Reconnect
the batteries. See the instructions in the section of
this book called "Battery Maintenance".
4. When battery inspection is completed, close the
recovery tank. Rotate the seat support back to the
operating position.

Cleaning the Recovery Tank and Filter

1. Turn the key switch to the "OFF" position.
2. Empty the recovery tank using the flexible drain
hose by unscrewing the knob and taking off the
plug (see figure 36).
3. If the machine is equipped with the optional clean-
out port, open the lower cleaning port cover by
unscrewing the four knobs (see figure 37). NOTE:
Make sure that the tank is empty first.
4. Rinse the tank and clean the drain plug.
Page -26-
Figure 36
Figure 37
Clarke ®
Operator's Manual (EN) - Focus Rider