Features And Technical Data - SATA Beropur HRS Mode D'emploi

Operating Instructions Beropur pressurised cup gun
Preface
Prior to putting the unit/pressurised cup gun into operation, read the operating instructions completely and
thoroughly. The stipulations contained therein are to be respected in any case. After that, the operating
instructions are to be stored in a safe place, accessible for every user of the equipment. The unit/pressu-
rised cup gun may only be put into operation by persons familiar with its use (professionals). Inappropriate
use of the unit/pressurised cup gun, modification of any kind or combination with inappropriate other parts
may cause material damage, serious hazard to the user's, other person's or animal's health or even death.
SATA shall not take any responsibility for such damages (e.g. failure to respect the stipulations laid out in
the operating instructions). The applicable safety, workplace and worker health protection regulations of the
respective country or area/district in which the system/the pressurised cup gun is used are to be respected
in any case (e.g. the German Rules for the Prevention of Accidents BGR 500 (BGV D25) and BGV D24
issued by the Central Office of the Professional Trade Associations, etc.).
To be noted
Never point pressurised cup guns at yourself, at other persons or animals. Solvents, thinners and cleaning
agents can cause burns. Only the respective quantities of solvents, paints and cleaning agents required
for work progress may be present in the direct surroundings of the unit (after work, solvents and paint
remainders are to be returned to their assigned storage rooms). Prior to any repair work the unit must be
disconnected from the air supply and all pressure must be released. Prior to putting the unit into opera-
tion, especially after each cleaning and each repair work, check all screws and nuts for tight fit, as
well as the sealing performance of the spray guns and hoses. Defective components must be replaced
or repaired accordingly. To obtain best possible coating results, and for maximum safety, only use original
spare parts. No sources of ignition (e.g. open flames, burning cigarettes, lamps without ex-protection etc.)
may be present during painting, as easily flammable mixtures are generated during the painting process.
Occupational safety regulations must be applied when painting (respiratory protection, etc.). No vibration
is transmitted to the parts of the operator's body during use of the pressurised cup gun. Recoil forces are
negligible. The use of this product in explosion hazard areas Zone 0 is prohibited. SATA, SATAjet, the
SATA Logo and/or other SATA products referenced herein are either registered trademarks or trademarks
of SATA GmbH & Co. KG in the U.S. and/or other countries. The names of companies and products men-
tioned herein may be the trademarks of their respective owners.
1. Construction
1 Check valve
2 Trigger
3 Material needle
4 Material needle packing (not visible)
5 HRS mixing cap
6 Material quick coupling

2. Features and technical Data

Pressurised cup spray gun with pressurised cup for one-way cans 1 l, connection 1 max. 10 bar, quick
coupling for wand connection
• Material flow control
• Weight (without material)
• Air consumption
• Air connection thread
• Nozzle size
• Cup contents for one-way cans
II.1
7 Pressurised cup
8 Air connection G 1/4 outside thread
9 Gun body
10 Closing screw
11 Extension pipe
12 Safety valve
1300 g
100 l/min (3,6 cfm)
G 1/4 outside
Ø 1,7 mm
1 liter