Intended Use; Safety Information - Sartorius Stedim Biotech Microsart e.motion Mode D'emploi

Intended Use

The Microsart e.motion dispenser is
used to unpack sterile packaged mem-
brane filters conveniently, reliably and
quickly and make them easy to
remove with tweezers.
The dispenser saves three steps that
are otherwise necessary during manu-
al removal, i.e.:
– Opening single packages
– Separating the sensitive membrane
– Removing the membrane from the
package
The dispenser can be adjusted so that
when tweezers are advanced towards
the separator slit it triggers the
unpacking of the next membrane.
The user can set the sensitivity and the
range of the optical motion detector
for triggering automatic membrane
dispensing.
An optional foot switch is also
available.
4 Intended Use

Safety Information

The dispenser complies with the
European Council Directives as well
as international regulations and stan-
dards for electrical equipment and
electromagnetic compatibility.
Improper use or handling, however,
can result in damage and|or injury.
Read these Operating Instructions
t
thoroughly before using Microsart
e.motion
! Do not use Microsart e.motion in zone
0, 1, 20, 21 or 22 hazardous
areas|locations.
! If you use electrical equipment in
installations and under ambient
conditions requiring higher safety
standards, you must comply with the
provisions specified in the applicable
regulations for installation in your
country.
– The dispenser may only be used with
the following AC adapter:
TNG6 Universal, order no. 6971966.
– During cleaning, never allow liquids to
enter the dispenser: Only use a slightly
moistened cleaning cloth.
y If any sign of damage is visible on the
equipment or the line cord: Discon-
nect the equipment from the power
supply and make sure that it is
protected against further operation.