Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Britax Child Safety, Inc.
Cup Holders
Installing the Cup Holders (Optional)
IMPORTANT:
DO NOT use cup holders with hot liquids�
1� Slide the cup holder into the booster base and press down until
a click is heard�
NOTE: The cup holders are labeled inside "L" and "R", from
the position of the child occupant, and can only be installed as
indicated.
Removing the Cup Holders
1� From under the booster base, locate the tab on the bottom of
the cup holder�
2� Pull forward on the tab to disengage the cup holder, then
remove it from the booster base�
NOTE: Cup holders are dishwasher safe.
NOTE: Cup holders can be removed to allow for side by side
seating positions.
14
Lower Anchor System
The lower anchor system helps to
anchor the booster seat into the car
for added stability and safety in the
event of a crash� The lower anchor
system does not restrain your child�
You must use the lap-shoulder belt
to properly secure your child.
The figure at right shows typical
locations for lower anchors in a
vehicle� Check your vehicle owner's
manual to learn if it is equipped
with lower anchors, information
on the lower anchor locations, and
designated seating positions available
for use with this child seat.
SKYLINE User Guide
LOWER ANCHORAGE SYSTEM LOCATIONS
Vehicle Seat
Head Restraint
Lower Anchors
27.9 cm (11 in.)
Lap-Shoulder
Vehicle Seat Belt
Vehicle Seat
Lower Anchors
Vehicle Seat
Belt Retractor
15
Publicité
Chapitres
Table des Matières
