Secureguard; Adjusting Secureguard Fit; Using The Retractable Cup Holders - Britax Parkway SG Guide De L'utilisateur

Using the Child Seat

SecureGuard

Britax recommends using the SecureGuard
to achieve best vehicle seat belt placement.
The SecureGuard clip should hold the lap
part of the vehicle seat belt in place. The
SecureGuard clip should be adjusted to
keep the lap part of the vehicle seat belt
positioned low across your child's upper
thighs (Fig. A). Ensure the bottom edge of
the SecureGuard clip is level with your child's
upper thighs, however, the clip itself should
not press into your child's upper thighs.
The lap part of the vehicle
IMPORTANT:
seat belt must not rest on the child's
abdomen.

Adjusting SecureGuard Fit

To Shorten:
1 Locate the SecureGuard adjuster
under the base. See page 13.
2 Pull the SecureGuard adjuster away
from the base.
3 Feed the webbing through the
SecureGuard adjuster (Fig. B).
4 Pull the end of the SecureGuard adjuster webbing to
tighten (Fig. C).
To Lengthen:
1 Locate the SecureGuard adjuster under the base. See
page 13.
2 Pull the SecureGuard adjuster away from the base.
18
3
4
a
5
The lower edge of the SecureGuard clip should be level
with the child's upper thighs once they have been secured
in the booster seat.
b

Using the Retractable Cup Holders

c
Pull the cup holder out from
the booster base to use.
IMPORTANT:
Feed the end of the SecureGuard
adjuster webbing through the
SecureGuard adjuster (Fig. D).
Pull the webbing to remove slack
from the SecureGuard adjuster.
Move the SecureGuard clip to the
center of the SecureGuard webbing.
• DO NOT use with hot liquids.
• DO NOT step on or put excess weight on the cup
holder.
Using the Child Seat
d
Push the cup holder into the
booster base to store.
19