Abicor Binzel MAG RB/RP Mode D'emploi page 25

MAG Welding torches
8.2 Changing the torch neck
CAUTION
Risk of injury
Burns caused by coolant spatter.
• Switch off the cooling circuit.
 4.1 Equipping the torch on page EN-6
8.3 Cleaning the torch neck
NOTICE
• Clean the gas nozzle interior regularly to remove weld spatter and spray it with original
ABICOR BINZEL anti-spatter fluid.
• Check the wear parts for visible damage and replace defective parts.
 Fig. 1 Type 61GD/610D on page EN-6
1 Remove gas nozzle (1).
2 Remove welding spatter and spray gas nozzle (1) and (2) using the ABICOR BINZEL anti-
spatter agent.
3 Check wear parts (2), (3), (4) for visible damage and replace them, if required.
9 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
BAL.0147 • 2018-11-09
9 Disposal
EN - 13