Pando PHT 9245 Guide Rapide D'utilisation page 44

3172941-000 EPIFA 25/02/16 09:03 Página 44
How to use the oven cleaning cycle
Always use the cleaning programme with a
cold oven. Running it with a hot oven may have
adverse effects.
1. First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
Caution
Do not clean the oven and tray at the same
time using the function as you will not obtain
good results. To clean the tray, follow the
instructions provided below.
2. With the oven cold, gently pour 250 ml of
water into the bottom of the oven cavity.
3. Touch the sensor
on.
44
to switch the oven
4. Turn the function selector anti-clockwise
until the symbol
timer display.
5. You will hear a beep indicating that the
Hydroclean ® has started. Symbol
will flash slowly and the time remaining to
complete the cleaning cycle will appear on
the display.
IMPORTANT
The duration of this cycle cannot be changed.
To stop before completion of the cycle, turn
the oven off by touching the sensor
6. When the cycle is finished, the oven will
turn itself off, an alarm will sound and sym-
bol will flash quickly.
7. Touch any sensor with your fingertip to stop
the alarm and to turn off symbol
8. Any traces of dirt and excess water can
now be removed with a damp cloth.
IMPORTANT
Do not open the oven door until the cleaning
programme has completely finished as the
cooling phase is necessary for it to work prop-
erly.
The cleaning programme should be done at a
low temperature. When it has finished, any
residue can be safely removed with a damp
cloth. Cooling times vary depending on the
room temperature. Before touching any inside
surface of the oven, check that it is cool.
appears on the
.
.