Pando PHT 9245 Guide Rapide D'utilisation page 42

3172941-000 EPIFA 25/02/16 09:03 Página 42
Any of the settings selected for the recipe can
be changed while the food is cooking.
As you touch the sensor
different symbols LO, ME, HI, kg and ºC will
flash on the temperature display. This is when
you can change your selection by turning the
temperature selector.
Important information about automatic cooking with Pando Chef
• When you select a recipe and enter a
weight, the oven automatically calculates
the temperature and cooking time needed.
Cooking time starts from a cold oven unless
pre-heating has been specifically indicated.
• It is therefore very important to select the
correct food weight so that the ingredients
will be properly cooked.
• With roasting programmes, after a certain
time has passed the oven will advise you
that the joint of meat should be turned over.
When this moment arrives, the oven will
beep. If the food is not turned over, the oven
will go on following the recipe.
• When cooking roast recipes, remember that
meat with a thick outer layer of fat will need
increased cooking time.
• Cooking time should also be increased
when cooking several pieces of meat at the
same time.
42
Adjusting the values for Pando Chef
Pando Chef, the
Touch the sensor
or else wait a few moments.
IMPORTANT
The weight of the food can only be changed in
the first 10 minutes of cooking time. After that
it will no longer be possible.
• For baking or gratins, remember that recipes
are calculated for a weight of 500g of flour
or 1 kg of raw potatoes or vegetables.
• If you want to cook larger amounts, you will
need to reduce the temperature slightly and
increase cooking time by about 10 minutes
per extra kg.
• If you want to cook smaller amounts, this
should be done with a shorter time and
higher temperature.
CAUTION
For bread (LO) and pizza base recipes, the
oven should be pre-heated first. In this way
the oven will be at the ideal temperature for
the best results.
to confirm the change