Mounting The Wing Bars; Mounting The Upper Wing - Reely Furious 3D Notice D'emploi

h) Mounting the Wing Bars
Glue the two wing bars to the lower wing with suitable
superglue as shown in figure 9.
Observe that the wavy shape of the bars points forwards and
the wing bars are glued on at an angle of 90° to the wing.
Continue to observe that the rear edge of the two wing bars is
tilted forwards.
We recommend that you try putting on the wing bars before
final connection with glue, see figure 10.
If the two wing bars are installed incorrectly, the cut-put in the
upper wing will not match!
Figure 9
i) Mounting the Upper Wing
Put the top wing onto the wing dome and the two wing bars
(figure 10).
Check for correct and non-distorted fit of the wings and rework
if required.
When everything is fitting correctly, glue the two wing bars and
wing dome to the top wing as shown in figure 10.
Figure 10
37