Elevator - Reely Furious 3D Notice D'emploi

k) Elevator
Cut the elevator from the dampening fin with a cutter knife as
already done with the wings.
As already known for the ailerons, the elevator must not rub
against the dampening fin when operated. Therefore, grind off
some material from the side of the elevator.
The elevator is also attached with a strip of hinged adhesive
tape (figure 12a).
Install a rudder horn from the linkage parts set to the bottom of
the elevator as shown in figure 12b.
Small strips of hinged adhesive tape must be applied to the
bottom of the elevator (figure 12b).
Figure 12a
Figure 12b
39