Mounting The Ailerons - Reely Furious 3D Notice D'emploi

e) Mounting the Ailerons
The ailerons at the top wing must not touch when the servo is operated.
Therefore, grind off a little material at the insides of both ailerons.
Put the top wing and both ailerons on a suitable, level surface.
Glue the ailerons to the top wing with a strip of hinged adhesive tape
(figure 6a).
Observe that a small gap must remain for good movement between wing
and aileron. The ailerons must be flush with the wing on the outside.
Figure 6a
Put the lower wing and both ailerons on a suitable, level surface.
Glue the ailerons to the lower wing with a strip of hinged adhesive tape
(figure 6b). Observe that a small gap must remain for good movement
between wing and aileron.
The ailerons must be flush with the wing on the outside.
Figure 6b
35