4
Handling and transportation
The stove is delivered complete with
all the parts provided.
Pay attention to the tendency to
unbalance the stove.
The centre of gravity of the stove is
moved towards the front.
Bear in mind the above also when
moving the stove on the transportation
support.
During lifting, avoid jerking or abrupt
movements.
Make sure the forklift truck has a
capacity greater than the weight of
the stove to be lifted.
The full responsibility of the lifting of
loads lies on the person handling the
lifting equipment.
Make sure that children do not play
with the packaging components
(e.g. films and polystyrene).
Danger of suffocation!
4.1 Removal from the transport pallet
To remove the stove from the transport
pallet, follow the instructions in the
annexed "Product Booklet".
44
5
5.1 General considerations
5.2 Safety Precautions
004778021 - 08/04/2021
Preparation of the installation
site
In the following paragraphs there are
some guidelines to follow in order to
obtain the maximum performance of
the product purchased.
T h e fo l l ow i n g i n s t r u c t i o n s a r e
nevertheless subject to compliance
with any laws and national, regional
and municipal regulations in force
in the country where the product is
installed.
Installation must be performed by
qualified personnel in compliance with
the EN 10683 standard.
The responsibility of the works carried
out in the area where the stove will
be installed falls, and remains, on
the user; the latter is also entrusted
with the execution of the inspections
related to the installation solutions
proposed.
The user must comply with all local,
national and European safety regulations.
The appliance must be installed on
floors with adequate load bearing
capacity.
The stove removal and installation
instructions must only be performed
by specialist technicians. It is always
recommended that users contact our
after sale service to request qualified
technicians.
In the case other technicians are
involved, it is recommended to verify
their actual abilities. The person in
charge of the installation, before
starting assembling or disassembling
of the stove, must comply with the
safety precautions required by law
and in particular:
• they must not operate in adverse
conditions