Handling And Transport; Type Of Fuel; Important - Palazzetti SUNNY FIRE Manuel D'installation Et D'entretien

3 HANDLING AND
TRANSPORT
The replace is delivered with an assembled metal
structure while the surround is in a separate package
suitable for long-distance transport. It is advisable to
wait until the replace arrives at the place where it will
be installed before unpacking it.
The replace is supplied with all its parts.
Pay attention to the stove's tendency to oscillate.
Avoid sudden movements and sharp tugs when lifting
the stove.
Make sure the lifting capacity of the lift truck is more
than the weight of the stove. The person manoeuvring
the lifting means is held completely responsible for lifting
loads.
Do not let children play with the packaging materials ( lm,
polystyrene). Suffocation hazard!
The Ecomonoblocco models are tted with special anchor
points for handling with special equipment (Fig. 3.1).
The monoblocchi equipped with sliding door are tted with
a counterweight lock system to ensure safe transport.
The safety lock for transport (-3.2-) must be removed
completely before mounting.
Check the proper operation of the sliding door before
covering the monoblocco.
- 3.1 -

4 TYPE OF FUEL

Ecomonoblocco models are to be fed preferably with
mature beech or birch wood or with wood briquettes.
Each type of wood has different characteristics that also
in uence combustion yield.
Use of pinewood (pine, r) is not recommended as it
contains high quantities of resin substances that quickly
clog the ue.
It is forbidden to burn: pieces of bark, wood treated with
varnish, pressed wood panels, coal, plastic materials;
in this case, the guarantee on the appliance is no more
valid.
IMPORTANT: the continuous and prolonged burning of
wood types rich of aromatic oils (e.g. eucalyptus, myrth,
etc.) will cause the rapid corrosion of the internal parts
of the appliance.
The declared nominal yield of the chimney is obtained by
burning the right quantity of wood, making sure not to
overload the combustion chamber. The ideal length of
the wood is provided by the length of the log holder.
The ideal length of the pieces of wood is of around 35
cm, which must be placed horizontally and not vertically.
Maximum allowable moisture content is 25%.
The reference standard for the fuel used is EN 14961-1
"Forest, plantation and other virgin wood".
- 3.2 -