Using For The First Time; Setting The Power - Trixie TR1000 Mode D'emploi

Using for the first time

• Oil the cutting set (Fig.5).
• Connect to the mains.
• Switch the equipment on using the On/Off switch (Fig. 1a) and, after use, switch it Off
again (Fig. 1b).
• Note:
The audible click that can sometimes be heard when switching the equipment on is a
result of the drive unit switching on. This is completely normal. A slight warming of the
equipment and vibrations during use are also completely normal.

Setting the power

The blade track is set at the optimum setting ex-factory. However, the blade track can
change as a result of voltage fluctuations. In the event of undervoltage, the blade track
can shorten and, in the event of overvoltage, it can lengthen. If necessary, by changing
the setting of the adjusting screw, you can set this blade track yourself. To do so, use a
screwdriver or a thin coin.
• Using the On/Off switch, switch the equipment on (Fig. 1a).
• Turn the adjusting screw clockwise until you hear a loud noise (Fig. 2b).
• Then turn the adjusting screw anti-clockwise until the loud noise stops (Fig. 2a).
Cutting-length adjustment
With the adjustment lever at the side, the cutting length can be steplessly adjusted, even
during operation.
• Lift the adjustment lever upwards - minimum cutting length (Fig. 3a).
• Lower the adjustment lever - maximum cutting length (Fig. 3b).
Clipper Set TR1000 · Operating instructions
23880
Item no.
9