Trixie TR1000 Mode D'emploi page 11

Changing the clipping comb and clipping blade
• Switch the equipment off using the On/Off switch (Fig. 1b)
• Disconnect from the mains.
• Undo both screws on the cutting set, remove the clipping comb and clipping blade (Fig. 6).
• When assembling, the clipping comb and clipping blade should be aligned as follows (Fig. 7).
• Raise cutting length adjustment lever – shortest cutting length (Fig. 3a).
• The distance between the front edge of the clipping comb and the front edge of the
clipping blade should be between 0.8 mm und 1.6 mm (Fig. 7a).
• The clipping comb and clipping knife should be parallel to each other.
• The first tooth of the clipping blade (from the left) must cover the first tooth of the
clipping comb or be located slightly to the left of this (Fig. 7b).
• The outermost tooth of the clipping blade (on the right) must touch the outermost
large tooth of the clipping comb (on the right) (Fig.7c).
• Tighten both screws (Fig. 6).
Disposal in EU Countries
Follow the appropriate laws and regulations for the disposal of the device. Information
for the disposal of electric and electronic devices in the European Union: In the European
Union the disposal of electric devices is regulated nationally, based on the EU-guideline
2012/19/EU for Waste Electrical or Electronic Equipment (WEEE). Accordingly, this device
may not be disposed of through the community or domestic waste collection services.
This device will be accepted at community collection points or recycling yards
free of charge. The product packaging consists of recyclable materials. Dispose
of these properly to protect the environment and ensure it can be reused or
recycled.
Dispsal in non-EU Countries
Please dispose of the device at the end of its service life in an environmentally friendly
way and according to the legal requirements.
CAUTION: Never handle your clipper TR1000 while you are operating a water faucet
and never hold your clipper under a water faucet or in water. There is danger of electrical
shock and damage to your clipper. The TRIXIE Heimtierbedarf GmbH & Co. KG will not be
responsible in case of injury due to this carelessness.
Clipper Set TR1000 · Operating instructions
23880
Item no.
11