Using For The First Time - Trixie Andis Mode D'emploi

• Use this appliance only for its intended use as described in this manual. Do not use attachments not recom-
mended by TRIXIE Heimtierbedarf GmbH & Co. KG.
• Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water. Return the appliance to TRIXIE Heimtierbedarf GmbH & Co. KG
for examination or repair.
• Keep the cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being
administered.
• Do not use this appliance with a damaged or broken blade or comb, as injury to the skin may occur.
• To disconnect turn control to "0" then remove plug from outlet.
• Warning: During use, do not place or leave appliance where it may be damaged by an animal or exposed
to the weather.
• Before using as well as after each use the blades has to be oiled. Blades may become hot during use.
Check often to prevent burning animal.
• Keep the appliance dry.
Save these instructions!

Using for the first time

Plug the cord into an electrical outlet, operate at 230–240 volt, 50 cycle AC electrical current or as noted
on the unit. To start the clipper move the switch button to the "ON" ("I") position. To stop, move the switch
button back to the original position. After using your clipper TR1500, rewrap the cord and store in a safe place.
Clipper blade adjustment
The clipper blade set is easy to adjust. From coarse to fine cuts, all that's needed is a flick of the adjustment
lever with your thumb. In the upright position, blades are set for the finest, or shortest cuts (Figure A).
Using the attachment combs
Some models do not have combs and sizes will vary by kit. You can set the blades for a longer cut by using
any of the attachment combs made for your clipper TR1500. The combs mount easily; simply slip the cutter
blade teeth into comb and snap the comb down. To remove, simply snap off (Figures B & C). These attach-
ment combs guide hair into the blades and give you precise control of hair lengths. The length of trim is indi-
cated on the attachment comb. Use the chart to find the approximate lengths of cut. Different blade angles in
relation to the skin, thickness and texture of the hair will vary the cutting length.
Description
Standard Blade TR1500
Attachment Comb 1/8" (3 mm)
Attachment Comb 1/4" (6 mm)
Attachment Comb 1/2" (13 mm)
Attachment Comb 3/4" (19 mm)
SNAP!
CLIPPING GUIDE
Clipping Direction
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
Clipper Set TR1500 · Operating instructions
OIL
Approx. Length of Cut
Fine
1/16" (1.6 mm)
1/32" (0.8 mm)
1/4" (6.4 mm)
1/8" (3.2 mm)
3/8" (9.5 mm)
1/4" (6.4 mm)
5/8" (15.9 mm)
1/2" (12.7 mm)
7/8" (22.2 mm)
3/4" (19.0 mm)
#23871
Coarse
3/16" (4.8 mm)
1/8" (3.2 mm)
3/8 (9.5 mm)
1/4" (6.4 mm)
1/2" (12.7 mm)
3/8" (9.5 mm)
7/8" (22.2 mm)
5/8" (15.9 mm)
1-1/8" (28.6 mm)
1" (25.4 mm)
7