Scan Sensitivity Setting - Fm - Sangean TRAVELLER 760 Mode D'emploi

Scan sensitivity setting – FM
Your radio will normally scan for FM broadcasts which are strong enough to give good
reception. However, you may wish the Auto-scan function to also be able to find weaker
signals, possibly from more distant radio transmitters. Your radio includes a local /
distant option for the Auto-scan function.
1.
When in FM mode, press and hold the Info / Menu button to enter the FM menu.
2.
Press the Tuning Up / Down button to select "Scan zone". Press the Select button to
enter the setting. The current scan setting is indicated with an asterisk.
3.
Press Tuning Up / Down button to choose either the 'Local' or 'Distant' option. The
Distant option will allow the radio to find
weaker signals when scanning.
4.
Press Select button to confirm the setting. The Local or Distant setting is stored in
the radio and remains in force until changed or until a system reset.
Stereo / Mono switching – FM
If the FM radio station being listened to has a weak signal, some hiss may be audible. It is
possible to reduce this hiss by forcing the radio to play the station in mono rather than stereo.
1
Ensure your radio is in FM mode and tune to the required FM station.
2
Press the Select button to switch to mono or stereo. The display will show
"Force mono" or "Auto Stereo". If the broadcast being received is in stereo,
then the stereo speaker symbol will be shown in the lower area of the display.
i
Force mono
018
i
Auto Stereo
FM
88.50 MHz
[Date Not Set]
FM
00:00