Headphone Socket; Factory Reset - Sangean TRAVELLER 760 Mode D'emploi

Headphone socket

A 3.5mm Headphone Socket located on the left hand side of your radio is provided for
use with headphones. Inserting a plug automatically mutes the internal loudspeaker.
Please be aware that the sensitivity of headphones can vary widely. We therefore
recommend setting volume to a low level before connecting headphones to the radio. It
is also recommended to reduce the volume before unplugging your headphones.
IMPORTANT
Excessive sound pressure from earphones and headphones can cause hearing
loss. To prevent possible hearing damage, do not listen at high volume levels for
long periods.

Factory reset

If you wish to completely reset your radio to its initial state this may be performed by following
this procedure. By performing a factory reset, all user entered settings will be erased.
1.
With your radio switched on, press and hold Info / Menu button to access the menu
for the current mode.
2.
Press the Tuning Up / Down button to select "System settings". Press the Select
button to enter the system settings menu.
3.
Press the Tuning Up / Down button to select "Factory Reset". Press the Select
button to enter the setting.
4.
Press the Tuning Up / Down button to select "Yes" or "No". If you do not wish to
carry out a system reset, select "No" and then press the Select button to confirm the
setting.
5.
With "Yes" selected, press the Select button. A full reset will be performed. All
presets and station lists will be erased. All settings will be set to their default values.
After a system reset, the radio will be restarted. The display will show "Welcome
to Digital Radio" and a scan of the DAB band III will be performed. In case of
malfunction due to electrostatic discharge, reset the product (reconnection of power
source may be required) to resume normal operation.
023