Scan Sensitivity Setting - Fm - Sangean DPR-69+ Mode D'emploi

Scan sensitivity setting - FM

Your radio will normally scan for FM broadcasts which are strong
enough to give good reception. However, you may wish the Auto-scan
function to also be able to find weaker signals, possibly from more
distant radio transmitters. Your radio includes a local / distant option for
the Auto-scan function.
1. Press the On/Off button to switch on your radio.
2. If needed, press the Band button to select the FM band.
3. Press and hold the Info button until the display shows "Mono override"
on the lower line.
4. Press and release the Tuning up or down buttons until the display
shows "FM Scan Zone" then press the Select button to enter the
scan zone selection menu.
5. Press the Tuning up or down buttons to switch between Local and
Distant options on the lower line of the display. The Distant option
will allow the radio to find weaker signals when scanning.
6. Press the Select button to confirm your selection. The radio will then
revert to the normal information display. The Local or Distant setting
is stored in the radio and remains in force until changed or until a
System Reset.
Note:
The intial setting (out of the box, or after a System Reset) causes the
radio to ignore weak (distant) signals.
GB
18