Operating Your Radio - Fm - Sangean TRAVELLER 760 Mode D'emploi

Operating your radio – FM
1.
Carefully extend the telescopic aerial.
2.
Press the On / Off button to switch on your radio.
3.
Press the Band button to select the FM band.
4.
To scan up in frequency, press and hold the Tuning Up button. (Alternatively, first
press the Tuning Up button and then press the Auto Tune button.) Your radio
will scan in an upwards direction (low frequency to high frequency) and stop
automatically when it finds a station of sufficient strength.
To scan down in frequency, press and hold the Tuning Down button. (Alternatively,
first press the Tuning Down button and then press the Auto Tune button.) Your radio
will scan in a downwards direction and stop automatically when it finds a station of
sufficient strength.
5.
After a few seconds the display will update. The display will show the frequency of
the signal found. If the signal is strong enough and there is RDS data present then
the radio will display the station name.
6.
When the end of the waveband is reached your radio will recommence tuning from
the opposite end of the waveband.
7.
Press the Volume Up / Down button to adjust the sound level as needed.
8.
To switch off your radio, press the On / Off button.
016