Use - Cleanmaxx 00142 Mode D'emploi

Use

CAUTION!
■ Never hold the suction nozzle (11) close to parts of the body or animals during use
and never reach inside in order to avoid injuries or becoming stuck to it. Should the
cordless vacuum cleaner become stuck, switch the device off immediately.
■ Only switch on the device once you have made sure that the dust container (12) and
the fi lter are inserted correctly.
■ Always switch off the device before replacing any accessories.
■ On no account should the device be used to suck up the following:
– liquids or wet substances (e.g. wet carpet shampoo)
– glowing ash, cigarette ends, matches, etc.
– infl ammable or explosive substances
– very fi ne dust (e.g. concrete dust), ash or toner
– pointed, hard objects such as large pieces of broken glass
■ Empty and if necessary clean the dust container (12) after each use (see the "Clean-
ing the Device and Accessories" chapter).
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
• If the suction performance diminishes, empty the dust container (12) and / or
charge up the battery.
• When the device is switched on or connected to the charging station (23), the
battery status is displayed. If all three battery control lamps (9) are lit up, the
battery is full. The fewer lamps are on, the lower the battery charge.
Floor Vacuum Cleaner
To operate the device as a fl oor vacuum cleaner, the cordless vacuum cleaner and the
turbo nozzle (7) must be inserted in the frame (6) (see the "Assembly" chapter).
1. Take the frame (6) with the cordless vacuum cleaner from the charging station (23).
2. Hold the turbo nozzle (7) with your foot and tilt the frame (6) downwards. This will
release the upright position.
3. The stem of the frame (6) contains the operating buttons (16):
Switch on/off
+ Increase suction power by one level
– Reduce suction power by one level
Switch the brush rotation in the turbo nozzle on/off
Switch on the cordless vacuum cleaner and guide the turbo nozzle (7) over the fl oor.
Switch on the brush for more in-depth cleaning. When the brush is switched on, the
control lamps (10) on the turbo nozzle (7) light up.
00142_de-en-fr-nl_A5_V1.indb 21 00142_de-en-fr-nl_A5_V1.indb 21
21
4. Fold down the stem (15) to vacuum under furniture. To do
this, pull the lever (8) beneath the handle (17) upwards. This
loosens the joint (1) of the frame (6) and makes it fl exible.
To allow easy handling, the joint of the turbo nozzle (7)
can be moved to the left / right as well as up and down.
EN
19.09.2016 12:36:56 19.09.2016 12:36:56