Maintenance And Cleaning; Error Codes - IKA Roller 6 basic Mode D'emploi

The device operates maintenance-free.
For cleaning disconnect the main plug.
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning agents for
cleaning purposes.
- Do not allow moisture to get into the appliance when cleaning.
- Please consult with IKA
®
mination methods, other than those recommended here.
Only clean IKA appliances using these IKA
®
agents:
Dirt
Dyes
Building materials
Cosmetics
IKA Roller 6/10 basic
®
Proceed as follows in such cases:
Switch the device off.
Perform corrective measures as described below.
Perform a restart.
Error Cause
Motor blockage or overload
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the IKA ® service department,
- Send the device for repair, including a short description of the fault.
IKA ® Roller 6/10 digital
The fault is shown by an error code in the display as following if the error occurs, e.g. Er 4.
Proceed as follows in such cases:
Switch the device off.
Perform corrective measures as described below.
Perform a restart.
Error Cause
Er 3 Temperature inside device is too
high
Er 4 Motor blockage or overload
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the IKA ® service department,
- Send the device for repair, including a short description of the fault.

Maintenance and cleaning

before using any cleaning or deconta-
approved cleaning
®
Cleaning agent
isopropanol
water containing detergent,
isopropanol
water containing detergent,
isopropanol
Motor off
Motor off
Motor off
Food
Fuels
Other materials
Spare parts order
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item and designation of the spare part, see
spare parts diagram and spare parts list
Repair
In case of repair the device has to be cleaned and free from any
materials which may constitute a health hazard.
of compliance" form from the IKA
If you require servicing, return the appliance in its original pa-
ckaging. Storage packaging is not su cient. Please also use sui-
table transport packaging.

Error codes

Solution
- Switch the device off.
- Reduce the load on the motor and check all moving parts for
freedom of movement.
- Then perform a restart.
Solution
- Switch the device off.
- Allow the device to cool down.
- Switch the device off.
- Reduce the load on the motor and check all moving parts for
freedom of movement.
- Then perform a restart.
water containing detergent
water containing detergent
please consult IKA ®
website
®
,
.
15