Flow-Through Housing Designations; Intended Use; Inappropriate Use - Mettler Toledo InFlow 76X Instructions D'utilisation

10
© 04/17 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
2.3

Flow-through housing designations

Housing designation as well as part and serial numbers can be noted from the type plate and
used for clear identification when communicating with the manufacturer.
NOTICE
The specifications shown on the type plate are dependent on the design and the individual type
of flow-through housing and have no general validity for the complete InFlow product range.
Example InFlow 76X label:
2.4

Intended use

The flow-through housings InFlow
mounting of the InTrac ® and InFit
pass (pipe). An electrode/sensor from METTLER TOLEDO, namely pH and Redox (ORP) combi-
nation electrodes as well as oxygen, CO
measurement. Use the flow through housings only for this purpose.
The following are also part of the stipulations for the correct and appropriate use:
– compliance with the instructions, regulations and information contained in this
instruction manual
– adherence to the prescribed inspection and maintenance/servicing intervals
– correct maintenance of the flow-through housings
– operation in compliance with prevailing regulations concerning the environmental and
operating conditions as well as with the admissible mounting positions
– observance of local legislation.
2.5

Inappropriate use

Any utilization other than the above mentioned, as well as any utilization that is not consistent
with the technical data is taken as being not in conformance with regulations. The operator bears
the sole risk for any damage caused by such utilization.
® 76X are designed and intended solely for safe and reliable
® series sensor housings directly into the process or in a by-
, conductivity or turbidity sensor can be installed for
2
InFlow 76X
InFlow 76X
52 403 711