Maintenance, Troubleshooting; Disassembly; Transportation, Storage, Disposal - Burkert 0312 Guide D'utilisation

The cable plug insert can be rotated through 4 x 90°.
→
Connect terminals.
→
Connect protective conductor.
→
Attach seal and check for correct fit.
→
Tighten cable plug (DIN EN 175301-803 (DIN 43 650), Form A);
while doing so, observe the maximum torque of 1 Nm.
→
Check electrical continuity between coil and body (protective con-
ductor function).
7.1 Malfunctions
If malfunctions occur, check whether:
→
the device has been installed according to the instructions,
→
the electrical and fluid connections are correct,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
Malfunction Possible cause
Valve does Short circuit or coil interrupted
not switch
Medium pressure outside the permitted pressure
range
Valve does Inner compartment of the valve is dirty
not close
If the valve still does not switch, please contact your Bürkert Service.
english
12
9 TransporTaTion, sTorage,
Disposal
note!
Transport damage.
Inadequately protected devices may be damaged during
transportation.
▶ Protect the device against moisture and dirt in shock-resistant
packaging during transportation.
▶ Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
Incorrect storage may damage the device.
▶ Store the device in a dry and dust-free location.
▶ Storage temperature -40 – +80°C.
Damage to the environment caused by parts contaminated
with media.
▶ Dispose of the device and packaging in an environmentally friendly
manner.
▶ Observe applicable disposal and environmental regulations.
7 MainTenance,
TrouBleshooTing
Danger!
Risk of injury from high pressure in the system/device.
▶ Before working on the system or device, switch off the pressure
and vent/drain lines.
Risk of injury due to electrical shock.
▶ Before working on the system or device, switch off the power
supply and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations
for electrical equipment.
Risk of burns/risk of fire if used for a prolonged switch-on
time through hot device surface.
▶ Keep device away from highly flammable substances and media
and do not touch with bare hands.
Risk of injury from improper maintenance work.
▶ Maintenance may be carried out only by trained technicians and
with the appropriate tools.
▶ Secure system against unintentional activation.
▶ Following maintenance, ensure a controlled restart.
english
8

DisasseMBly

Danger!
Risk of injury from high pressure in the system/device.
▶ Before working on the system or device, switch off the pressure
and vent/drain lines.
Risk of injury due to electrical shock.
▶ Before working on the system or device, switch off the power supply
and secure to prevent reactivation.
▶ Observe applicable accident prevention and safety regulations for
electrical equipment.
Risk of injury from improper disassembly.
▶ Disassembly may be carried out only by trained technicians and with
the appropriate tools.
→
Turn off the pressure and vent the lines.
→
Switch off the power supply.
→
Loosen the cable plug.
→
To remove the valve, remove the two unmarked screws only.
english
Type 0312
11
13