Inserting Batteries/Rechargeable Batteries For Receiver; Inserting Glow Plug - Reely ROAD Storm Devil Notice D'emploi

c) Insert Batteries/Rechargeable Batteries for Receiver
Remove the individual safety clips (see figure in chapter 8,
a) and take off the lid of the battery/receiver body.
In the battery/receiver box, there is a battery/rechargeable
battery holder (A) for 4 AA/mignon type batteries/rechar-
geable batteries.
After insertion of the batteries or rechargeable batteries,
A
insert the battery/rechargeable battery holder into the bat-
tery/receiver box again.
Alternatively, you can also use a 5-cell hump battery pack
for the receiver power supply.
Wrap the receiver, e.g. in a little foam to protect it from
vibration.
Close the battery/receiver box again and insert the safety
clips removed at first
d) Inserting Glow Plug
The manufacturer may already have inserted the glow plug in the cylinder head. In this case, check if it is screwed on
correctly. If the glow plug is enclosed separately from the motor, it must be screwed into the opening of the cylinder
head with a suitable glow plug key. Do not use any force for this.
Glow plugs wear, especially during the breaking-in stage. If tinder has formed on the glow coil, there may be problems
with starting or operation.
Therefore, we recommend that you always keep some glow plugs at hand for replacement. There are glow plugs with
different heat values.
Use glow plugs for RC cars only! The wrong glow plug, e.g. for a 4-cycle plane engine, will cause the engine to run
incorrectly and impairs reconciliation.
Generally, the following rule applies: The higher the nitromethane share in the fuel, the „colder" the glow plug should
be. This also applies the higher the ambience temperature when driving.
A „hot" plug must be used at low nitromethane ratios (e.g. for breaking in the motor) or low outdoor temperatures.
45