Ameda Mya Mode D'emploi page 18

4.8. After Every Use: Cleaning the Milk Collection Kit
1. Remove tubing from the back-flow protector
2. Set aside tubing, it doesn't not need to be washed after
each use— milk does not come into direct contact with it.
Take apart the remaining parts: the flange(s), valve(s),
back-flow protector(s), separating out the top, silicone and
bottom pieces, and milk storage bottle(s), including locking
ring(s) and locking disc(s).
ALWAYS wash hands well
with soap and water.
CLEANING: Cleaning with warm, soapy water.
After every use, unless otherwise directed by your healthcare provider, prepare
the product for use as follows:
1. RINSE any milk from pump parts with
cool water.
2. Hand WASH with warm, soapy
water, the flange(s), back-flow
protector(s), valve(s) and (if applies)
bottle(s), locking ring(s) and locking
disc(s). Wash valve(s) and back-flow
protector(s) silicone gently.
18
3. RINSE with warm, clean water the
flange(s), back-flow protector(s),
valve(s) and (if applies) bottle(s), locking
ring(s) and locking disc(s).
4. Air DRY each part on a clean surface.
*Pump parts may vary.
WARNING
DO NOT wash or
boil tubing. Tubing
needs to remain
dry to avoid any
potential mold
contamination.