Cleaning - Cleanmaxx CP-CY3811A Mode D'emploi

EN
1. Make sure that the accessories are attached correctly to the device (see the "Assem-
bly" chapter).
2. Pull the mains cable out of the housing as far as the yellow marking. Do not pull it any
further than the red marking!
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Press down the
5. Adjust the suction strength using the suction strength control (4).
6. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
7. Press the
8. Pull the mains plug out of the plug socket, hold the mains cable securely and press
the button for winding up the cable (3). Holding the mains cable prevents any
"whiplash" effect of the mains cable.
9. To ensure optimum performance of the device, clean the dust container (7) and all
fi lters regularly (see the "Cleaning" chapter).

Cleaning

CAUTION!
■ Empty the dust container at the latest when it is fi lled up to the MAX mark!
■ Always remove the mains plug from the plug socket before cleaning the device.
■ Keep the device, the mains cable and the mains plug away from water or other liq-
uids in order to avoid electric shocks. No liquid must be allowed to get into the device
when cleaning the device. Only the dust container, the screen of the dust fi lters, the
micro-dust fi lter and the motor exhaust air fi lter may be cleaned with water. They
must be completely dry before they are put back into the device.
■ The fi lters are neither machine-washable, dishwasher-safe nor suitable for tumble
drying! Only ever dry the fi lters in the air, and never use a hair dryer to do so.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.
The fi lters may lose some of their colour over time. This is normal and does not
have any adverse effect on function.
• Clean the fi lters regularly, or if you notice a reduction in the suction power.
• Clean the housing with a damp, soft cloth if necessary. Then dry it with a soft cloth.
• Regularly remove hair and fl uff from the nozzles.
On / Off switch (5) to switch on the device.
On / Off switch (5) again after vacuuming to switch off the device.
Tip: The handle (1) is equipped with an exhaust air
valve (12). To reduce the suction force when vacu-
uming upholstery, rugs or light, movable objects,
open the exhaust air valve (12) by sliding. Normally
the exhaust air valve (12) should be closed so that
the suction force is not unnecessarily reduced.
22