Specification; Connections And Controls - ROBBE RO-WING 300 Notice D'utilisation

Of course, you can also use this gyro to stabilise a fixed-wing model around the lateral
(pitch) or vertical (yaw) axis. In this case you only need to loop one servo function through
the gyro, and connect the elevator or rudder servo to the gyro. The piezo gyro must be
installed in the correct orientation relative to the axis to be stabilised. Pages 15 and 16 pro-
vide full details of this.
The gyro features a special temperature compensation circuit which ensures that the gyro
operates accurately, without drift problems, over the full temperature range.
The RO-WING 300 has no mechanical components which would be vulnerable to damage
or failure. It is entirely electronic in operation, and is therefore completely reliable and not
subject to wear.
2. Contents of set
RO-WING 300 fixed-wing gyro
Operating instructions
Two pairs of self-adhesive absorbent foam strips
3.

Specification:

Operating voltage:
Current drain:
Weight:
Dimensions:
Further performance features of this gyro:
- Gyro gain adjustment within the range 0% to 100% via auxiliary transmitter channel
- When switched on, the gyro adopts the current stick position as its neutral point
- Gyro suppression when the pilot gives an aileron control command, but not when both
ailerons are moved in the same direction
- Automatic zero point and temperature calibration when gyro is switched on
- Monitor LED to indicate "ready" state
- Servo reverse switches for both aileron functions
4.

Connections and controls

The RO-WING 300 is fitted with extra-long servo and socket leads, which makes it easy for
you to install the gyro in the most favourable location in the model.
You can reverse the direction of rotation of either or both servos by means of switches, ope-
rated using fine-tip tweezers or a small screwdriver.
This feature makes it simple to set up the gyro system to suit the existing servo arrange-
ment in your model aircraft. The red monitor LED indicates when the gyro is ready to use.
Operating instructions
Gyro RO-WING-300
3 - 8 Volts from receiver output
approx. 30 mA (at 4.8 V)
approx. 35 g
41 x 41 x 20 mm
13
Order No.
8418